Sandscent fence

The construction of a sandstone fence is quite laborious and it consists of different stages. First of all, it is necessary to mark the territory. There should be no curvature in the design of the fence. Stone fence should be even and without flaws.

Next, it is necessary to build the foundation. For heavy sandstone fences, this is necessary. The foundation can be made strip. In this case, the waterproofing layer will also not interfere. Pillars are paid to poles — in the places where they will stand, make a frame from reinforcement to strengthen. In addition, they build formwork from boards for the future pillar. To lay stones, make a cement-sand mortar. The amount of cement is three times less than sand.

First, the foundation is covered with a layer of solution. Then stones are laid on the solution. Stones must be adjusted to each other as denser as possible. All small holes must also be filled with a solution. It is important to know that the front (external) side of the masonry should be flat — so aesthetically and safer for others. Therefore, before starting work, stones are polished, beaten with a hammer, and only then they begin to direct laying.

If the solution suddenly falls on the front side of the masonry, you need to remove it with a brush. Water should not be used. You can strengthen the fence with an insert of the reinforcement, lay the rods every half meters. Upon completion of the work, the seams are being put.