Brack capture: what you need to know before the start of the process

For lifting the beams, it is required to capture them at least two points. For beams, as well as for columns, with all seizure methods, capture axes and traverses are usually used. Due to the fact that the beam remains when lifting in a horizontal position, both shoulders of the traverse can be shorter than when lifting the columns. The traverse is usually made entirely in the form of a metal structure. If you are looking for a temporary housing, then a wide selection here — apartments for rent in Belgorod inexpensively. Instead of axial captures and traverse, captive clamps can also be used. At the places of installation of clamps in concrete, the appropriate recesses are depressed on the working floor. The capture of beams with light weight can be carried out using a closed cable without the use of clamps. In the same figure, you can see temporary support for the Mr. A design feature in this case is that the butt of the Mr.-shaped columns was carried out not directly above the foundation, but at the site of the point of minimum moments. The method of temporary setting of the column, capture axes and traverse are also visible. The welding of the rods at the junction of the column is finished, the reinforcement is installed. For the rise of the previously described beams, two mounting cranes were required. One tap is enough to raise small -sized beams. However, in this case, the use of the traverse connecting both points of the capture is required, which can be made using cable slings.