Roof device
During construction on technology using LSTK, the roof overlap is made according to the project from the profiles of the calculation section. The roof design can be carried out in two methods, depending on the size of the overlapped span and the functional load of the attic or attic:
If it is necessary to block large spans, from 6-9 meters, the enzyme structures are installed on which the roof is located on top, and the ceiling and insulation are mounted on the lower part of the farms. Thus, the roof and the attic are located in the cold zone, and the design of the ceiling is made of thermal profile and provides thermal insulation and sound insulation of the living room.
If it is necessary to create an attic, the roof is made insulated. In this case, the attic is formed from the LSTK profile and the roof overlap. Thermoprofil is used as bearing beams.
On top of the beams are covered with a profiled sheet, fixed with self -tapping screws, then covered with a windproof film, the roof sheets are installed and fixed, on which the roofing system is laid and fixed and fixed.
Below the roof overlap cavity is filled with heat -insulating material, covered with a steam -barrier film, a system of acoustic mounts and ceiling profiles is installed, with subsequent lugging with drywall sheets.
