Any room provided for a future bathroom cannot be used without excellent ventilation. But what to do if the wiring is not suitable for the ventilation shaft? In this case, we will connect the fan directly to the lamp in your bath. We will use the Vents fan with low energy consumption (5.5 W) and 100 mm in size. To install the electrical appliance in the mine, it is necessary to use a special glue on a polymer basis, which is applied to the cover of the device with each of the four sides. We connect the adhesive surfaces (fans and walls) and immediately tear off, wait a minute and press the fan to the surface of the wall. Now you can deal with the power supply. Install the box for the cable, which is supplied with the same company as the fan. We will glue to the wall with glue. This is followed by electrical work. To connect the wires, it is recommended to use terminal pads (no twists). By the way, the lift rental service is now popular now, it is not very expensive.
This is much more convenient and safer. After that, the lamp is put in place. Now remove the fan cover and attach the end of the wire to its contacts. There is already a terminal connection in the device. After that, close the insides of a silent fan. Now, finally, you can relax in a hot bath. Solving the problem of lack of ventilation is quite easy.
