Under the influence of groundwater, the walls of the basement are constantly wet, and sometimes, even at all, pass water, which fills the entire cellar. And it can be very dangerous! You can cope with this trouble using a special pasta and sludge. If the problem is deeper, then it is necessary to work on a certain system in several stages. Step Preparation of the surface. Remove the remains of the old plaster from the wall, about half a meter around the leakage site. It will also be necessary to clean the seams of brickwork from the solution a couple of centimeters deep. Thoroughly cleaning the wall is the key that the sealant will be better to hold.
Want to buy a boiler for heating for yourself, but do not know where cheaper? We advise you to buy heating boilers on our website
Step preparation of sealant.
To do this, pour into some shallow capacity (old pot or bowl) a special mixture and prepare a separate dry cement.
Step performance of work.
Take a pure sealant and cover the cracks with a large brush. Then you need to immediately fall asleep this place with a cement and grind it. If water still oozes, repeat the whole process again.
Step the final stage.
After the sealing paste dries, the mixture for plastering the wall should be prepared, in compliance with proportions 1:
