Lining linoleum refers to simple finishing work, will cope with it for everyone. Contrary to common opinion, you should not lay linoleum on each other, so first of all you have to remove the old coating. If the clean floor is done for the first time, then align the surface, if necessary, arrange a screed. Then primed the floor, a good primer will protect you not only from unwanted dust, but also from mold.
If the room is usually crowded, then it makes sense to glue linoleum to the floor. This will prevent the coverage of the coating, as well as the formation of gaps at the joints. In principle, linoleum can also be laid dry, especially in small rooms, as well as in cases where there are no welded joints on the coating. Remember, if you have chosen a dry method of linoleum flooring, then it needs to lay down. Roll up a roll and leave it for a day. If linoleum bends the edges — put the load on it. Only after that it will be possible to cut the sheet, install skirting boards and thresholds. Make trimming with an ordinary stationery knife. If there is a joint between different sheets of the coating, it is recommended to «cook» them. Simply put, glue it. To do this, use a special glue used on the low -fat edges of the paintings.
